ESS-S3011A & GT30RA Electrostatic Discharge Simulator | NoiseKen

FEATURES

• EN/IEC 61000-4-2 Ed2 Compliant 
• ISO 10605 Ed2 Compliant    (Note: Optional gun head and CR units are required.) 
• Pre-test 
• "3 pre-checking functions” taking the confirmable test into the account
• "CR constant indicator” to ensure correct attachment is in place

• During test
• “Ten-key & Rotary knob” to ease the setting
• “Infra-red Remote Controller” to allow remote Generator setting
• “Discharge Detecting Function” to realize the air-discharge confirmation
• “Lightest Discharge Gun in the market” for better continuous operation
• “White LED light” to show Discharging points  

•  After test
• “Control Software” for Test Result Reporting and PC Control

DOWN LOAD HERE !

Achieve more reliable tests with "3 pre-check functions"

The new ESD simulator is equipped with 3 pre-check functions, "high voltage power output check", "insulation failure check", and "discharge relay operation check" on the main body and discharge gun.

You can prevent troubles such as,  if you did not notice the failure of the tester body or the relay inside the discharge gun had reached the end of its life, you could not perform the test properly in the past!

In addition, you can check immediately with a simple operation by following the instructions of the tester with the pre-check function.

"CR constant indicator” to ensure correct attachment is in place

The constants of the discharge resistance and discharge capacitor, which were previously disassembled and checked, are now displayed on the main unit screen.
It is automatically recognized and the type is determined when the CR unit or discharge cup of the discharge gun is replaced, or when the power of this product is turned on, it is automatically recognized and the type is determined.
The CR unit and the discharge cup are identified separately, and if the combination complies with the standard, the conforming standard is displayed at the bottom of the main menu.

Discharge detection function that can check the presence or absence of discharge.
 

In the previous test, the presence or absence of discharge could only be confirmed visually, but the new ESD simulator is equipped with a discharge detection function.
When electrostatic discharge is performed, the presence or absence of discharge can be confirmed by the buzzer sound of the tester body and the LED of the discharge gun. 

Achieves improved weight balance and weight reduction! Easy-to-hold and easy-to-use discharge gun!

“Improved balance of center of gravity and reduced weight by about 20%”
Of course! It is compatible with existing  ESD generators.